How to Reset Canon MP145 Printer
Reset Canon MP145 Printer
How to Reset Canon MP145 Printer - Actually, to reset the printer canon is almost the same for all series. Only a few differences on the steps. But, to reset canon MP145 printer software is not needed, but everything is done in hardware. How do I reset the MP145 printer? Please follow the instructions below:
The steps are as follows:
- Turn off the printer Canon MP145.
- Press and hold the Stop / Reset (red inverted triangle icon).
- While still pressing the Stop / Reset, Press and hold the Power button.
- Remove the Stop / Reset without removing the Power button.
- Double Click the Stop / Reset, here the printer will enter the service mode, where the printer will not work until we are out of service mode.Lepaskan Power button
- Wait a moment until the printer is doing warming up, and when the printer is loaded, (green indicator light) press the Stop / Reset key four times quickly.
- Turn off the printer to exit the service mode.
- Turn on the printer again, klo printer is not showing an error, then reset the Canon MP145 has been successful.
How to reset the Canon MP145 I have tried and succeeded. Please follow the above tips to bear their own risk ..
ERROR CODE AND RESET CANON MP145, MP160
E2-2 = No paper (ASF)
E3-3 = Paper jam
E4 = no ink / cartridge
E5-5 = ink cartridges are not installed or installed incorrectly cartirdge (not-compatible)
E8 = absorber full, or platen waste ink absorber full reset mita
E9 = connection to a digital camera / video camera does not support
E14 = Ink Cartridges Whose destination are wrong
E15 = Ink cartridge is not installed E16 - Ink remaining is unknown
E16-E19 = problems on the scan head alignment sheet
E22 = Carriage error
E23 = Paper feed error
E24 = Purge unit error (part dry pump head)
E25 = ASF (cam) sensor error
E26 = Internal temperature rise error
E27 = ink absorber full or platen waste ink absorber full> reset with such tools
E28 = Ink cartridge temperature rise error -
E29 = EEPROM error
E33 = Paper feed position error
E35 15 = USB Host VBUD overcurrent error - USB
E37 17 = Abnormal motor driver
E40 20 = Other hardware error
E42 22 = Scanner error
How to reset CANON WASTE INK COUNTER MP160/MP145
Before you reset the check error message contained in your printer lcd:
the method below is used to fix a printer that has a message ERROR E27
1. Turn off the printer (make sure the power cord is still attached), press and hold the STOP / RESET and then press and hold the ON / OFF and release the STOP / RESET,
then press the STOP / RESET 2x
2. Release both buttons, the printer is now in a position SERVICE MODE (the printer's LCD show the number "0")
3. Having the lights on / off green, please press the STOP / RESET in accordance with the following instructions:
- The press 1x = Orange flame lights> for Service pattern print
- The press 2x = Green flame lights> for EEPROM print
- The press 3x = Orange flame lights> for EEPROM reset
- The press 4x = Light Green Flame> for Waste ink counter reset
4. Turn off the printer and unplug the POWER.
5. Relive your printer.
